Servo Magazine ( March 2008 )

Building a Stepper Mottor Controller | Part 2

By Fred Eady    View In Digital Edition  

Now that I have a Minebea 29SM-K series 1.8°-per-step stepper motor shaft spinning back and forth on the bench, I figured it might be a good time to sit down and tell you how I persuaded an STMicroelectronics L6208PD to push current through the Minebea’s stepper motor coils. Unfortunately, I can’t provide a visual play-by-play of my Minebea’s alternately spinning motor shaft. However, I can give you a description of the hardware and software stuff you will need to make your motor spin under ...


Read This Article!
If you’re a subscriber and your subscription includes this issue of SERVO, you can read this article in our digital edition by clicking the blue "View In Digital Edition" button above.. Use the email address associated with your subscriber services account to login.

If you're a member of our Preferred Subscriber Network, not only will the magic blue button let you read this article, but EVERY article in EVERY issue is yours to enjoy! Over a decades worth of content is stored in our digital archive!

If you’re not a subscriber, you can still view a few sample pages of our digital edition or subscribe here for full digital access and/or print delivery. Also, as you browse around our site, you will find selected articles have been posted in their entirety for you to enjoy.


03.2008 | L6208 Motor Driver Board

Article Comments