Hack your Servo V1.00

Provided you have the tools and the servo you can built this for under a couple of bucks. The actuator extends with a rate of about 50mm/min. It is rather slow but very powerful. Watch my video at the end of the post where the small actuator lifts 10kg vertically. I will be giving instructions based on the dimensional parameters of the Hitec HS-300. The procedure remains the same for any type servo. I strongly recommend you read the whole post before you start. So lets make a start, shall we?





[Source] Hack your Servo V1.00


Posted by Michael Kaudze on 01/20 at 10:46 AM


Comments



<< Back to blog